Ethoam Endpoint Rfp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam endpoint rfp

Enables or disables the Remote Fault Propagation (RFP) on MEP.
ethoam endpoint mep_id domain {md_name | mac_address} association ma_name rfp {enable |
disable}
Syntax Definitions
mep_id
md_name
mac_address
ma_name
enable
disable
Defaults
The default value of RFP is disable.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The mep_id specified must already exist in the switch configuration.
•
The domain and association must be created before RFP can be enabled.
•
The MEP must be an UP MEP. If down MEP is specified, CLI returns with an error.
•
The admin state of the MEP must be enabled in order to report faults.
•
RFP cannot be enabled on virtual UP MEP since it is not associated with a physical interface.
•
It is recommended that if RFP is enabled on a port, then any other violation feature (Link Monitoring
or Link Fault Propagation) should not be configured.
•
It is recommended that if RFP is enabled on a port, then automatic recovery is disabled for that port.
•
If Link Monitoring is configured on a RFP enabled port, then the wait-to-restore timer must be less
than the CCM interval.
Examples
-> ethoam endpoint 1 domain md1 association ma1 rfp enable
OmniSwitch CLI Reference Guide
Specifies the Maintenance Association End Point. The valid range is
1–8191.
Specifies the domain name used while creating the management domain
for which this management association is created.
Specifies the CFM system MAC address.
Association name of the Ethernet OAM Association. Up to 48 (minus
the domain name length) characters may be used.
Administratively enables RFP on MEP.
Administratively disables RFP on MEP.
June 2012 page 45-29