Efm-Oam - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

LINK OAM Commands

efm-oam

Enables or disables the LINK OAM protocol on the switch.
efm-oam {enable | disable}
Syntax Definitions
enable
disable
Defaults
By default, the LINK OAM protocol is disabled for the switch.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
LINK OAM must be enabled globally for the OAM to be functional on all the ports.
•
When LINK OAM is disabled globally, all dynamically learned information on the port, including peer
information, is deleted. However, the LINK OAM configuration for the port is retained.
Examples
-> efm-oam enable
-> efm-oam disable
Release History
Release 6.4.2; command was introduced.
Related Commands
efm-oam port status
efm-oam port mode
show efm-oam configuration
MIB Objects
alaDot3OamStatus
OmniSwitch CLI Reference Guide
Enables the LINK OAM protocol.
Disables the LINK OAM protocol.
Enables or disables LINK OAM protocol on the specified port or on
a range of ports.
Configures the LINK OAM mode on the port or on the range of
ports to active or passive.
Displays the global LINK OAM configuration.
June 2012 page 46-3