Show Router Ldp Parameters - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show router ldp parameters

Displays the global LDP parameter values (graceful restart, interface, and targeted session) for the local
router.
show router parameters
Syntax Definitions
N/A.
Defaults
N/A.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
The interface parameters displayed with this command are global values that serve as default values for
individual LDP interfaces. Note that parameter values configured for a specific interface override the
global values.
Examples
->show router ldp parameters
LDP Parameters (LSR ID 10.10.0.7)
Graceful Restart Parameters
Fwd State Hold Time (sec):
Nbor Liveness Time (sec):
Interface Parameters
Keepalive Timeout (sec):
Hold Time (sec):
Propagate Policy:
Deaggregate FECs:
Label Distribution:
Control Mode:
Targeted Session Parameters
Keepalive Timeout (sec):
Hold Time (sec):
Passive Mode:
output definitions
Graceful Restart Parameters:
Fwd State Hold Time (sec)
page 48-66
120,
120,
30,
15,
system,
False,
downstreamUnsolicited, Label Retention:
ordered,
40,
45,
False,
The amount of time, in seconds, that the LDP router retains its MPLS
forwarding state after a graceful restart. Configured through the
configure router ldp fwd-state-holding-time
MPLS LDP Commands
Reconnect Time (sec):
Max Recovery Time (sec): 120
Keepalive Factor:
Hello Factor:
Transport Address:
Route Preference:
Loop Detection:
Keepalive Factor:
Hello Factor:
Targeted Sessions:
command.
OmniSwitch CLI Reference Guide
120,
3,
3,
system,
9,
liberal,
none
4,
3,
Enabled
June 2012