Ethernet-Service Nni - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ethernet-service nni

Configures the vendor TPID value, the legacy BPDU processing status, and the transparent bridging status
for a VLAN Stacking Network Network Interface (NNI).
ethernet-service nni {slot/port1[-port2] | agg_num} [tpid value] [{stp | gvrp | mvrp} legacy-bpdu
{enable | disable}] [transparent-bridging {enable | disable}]
Syntax Definitions
slot/port1
-port2
agg_num
value
stp
gvrp
mvrp
legacy-bpdu enable
legacy-bpdu disable
transparent-bridging enable
transparent-bridging disable
Defaults
parameter
value
stp legacy-bpdu enable | disable
gvrp legacy-bpdu enable | disable
mvrp legacy-bpdu enable | disable
transparent-bridging enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command only applies to ports configured as VLAN Stacking NNI ports.
page 44-10
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID number (0–31).
Specifies the TPID value of the port.
Specifies Spanning Tree legacy BPDU support.
Specifies GVRP legacy BPDU support.
Specifies MVRP legacy BPDU support.
Enables the specified legacy BPDU support.
Disables the specified legacy BPDU support.
Enables transparent bridging.
Disables transparent bridging.
default
0x8100
disable
disable
disable
disable
VLAN Stacking Commands
OmniSwitch CLI Reference Guide June 2012