CMM Commands
copy flash-synchro
Copies the certified directory version of the primary CMM software to the certified directory of the
secondary CMM.
[configure] copy flash-synchro
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is used to synchronize the certified directories of the primary and secondary CMMs.
The two CMMs must be in synchronization if a fail over occurs, otherwise switch performance is lost.
•
If the switch is part of a stack, all switches in the stack are updated with the primary CMM files.
Examples
-> copy flash-synchro
-> configure copy flash-synchro
Release History
Release 6.1; command was introduced.
Related Commands
copy working certified
MIB Objects
chasControlModuleTable
csEntPhysicalIndex
chasControlVersionMngt
OmniSwitch CLI Reference Guide
Copies the working primary flash version of the CMM software to cer-
tified primary flash. Or copies the working primary flash version of the
CMM software to startup secondary flash.
June 2012
page 53-15