port-security release
Releases a port that was shut down due to a Learned Port Security (LPS) violation. The specified port
resumes normal operation without having to manually reset the port or the entire module.
port-security slot/port[-port2] release
Syntax Definitions
slot/port
-port2
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command restores the port to the same operational state it was in before the shutdown. This
includes the activation of any existing LPS configuration for the port.
•
Note that when this command is used, all MAC addresses known to the specified port are flushed from
the switch MAC address table.
Examples
-> port-security 2/14 release
-> port-security 4/10-15 release
Release History
Release 6.1; command was introduced.
page 40-18
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3). Use a hyphen to specify a
range of ports on the same module (e.g. 3/1-16).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Learned Port Security Commands
OmniSwitch CLI Reference Guide
June 2012