Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3015

LINK OAM Commands
output definitions (continued)
Operational Status
Loopback Status
Mode
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
The status of the port in discovering whether the peer has LINK OAM
capability or not.It has the following states:
•
activeSendLocal: Specifies that the LINK OAM port is
actively trying to discover whether the peer has LINK OAM
capability but has not yet made that determination.
•
sendLocalAndRemote: Specifies that the local LINK OAM
port has discovered the peer but has not yet accepted or
rejected the configuration of the peer. The local device will
then decide that the peer device is acceptable or unacceptable
and then accept or decline LINK OAM peering.
•
sendLocalAndRemoteOk: Specifies the state when LINK
OAM peering is allowed by the local port.
•
oamPeeringLocallyRejected: Specifies the state when the
local OAM entity rejects the peer OAM entity.
•
oamPeeringRemotelyRejected: Specifies the state when the
remote LINK OAM port rejects the peering.
•
operational: Specifies the state when the local LINK OAM
port learns that both the local LINK OAM entity and the
remote LINK OAM entity have accepted the peering.
•
nonOperHalfDuplex: Specifies the value nonOperHalfDu-
plex is returned whenever LINK OAM is enabled. Since LINK
OAM functions are not designed to work completely over half-
duplex interfaces, the value nonOperHalfDuplex is returned
whenever LINK OAM is enabled but the interface is in half-
duplex operation.
•
linkFault: Specifies that the link between the host and the peer
has detected a fault.
•
passiveWait: Specifies that the LINK OAM ports are in
passive mode.
The state of remote loopback. It can be initiatingLoopback, terminat-
ingLoopback, localLoopback, remoteLoopback, noLoopback, or
unknown.
The state of LINK OAM mode, active or passive.
June 2012 page 46-29