Configure Router Ldp Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MPLS LDP Commands

configure router ldp shutdown

Configures the administrative status of the Label Distribution Protocol (LDP) instance on the router.
configure router ldp {no shutdown | shutdown}
Syntax Definitions
no shutdown
shutdown
Defaults
By default, LDP is enabled for the switch.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Disabling the LDP administrative status also disables any associated Label Switch Paths (LSPs) and
any Service Distribution Points (SDPs) that were attached to the LSPs.
•
When LDP is disabled on the switch, attaching SDPs to any of the associated LSRs is not allowed.
Examples
-> configure router ldp shutdown
-> configure router ldp no shutdown
Release History
Release 6.4.2; command was introduced.
Related Commands
show router ldp status
MIB Objects
vRtrLdpGeneralTable
vRtrLdpGenAdminState
OmniSwitch CLI Reference Guide
Enables the LDP administrative status on the router.
Disables the LDP administrative status on the router.
Displays status information and statistics for the LDP instance on the
local router.
June 2012 page 48-3