Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2783

Learned Port Security Commands
•
LPS is not supported on 10 Gigabit Ethernet, link aggregate, or 802.1Q tagged link aggregate (trunked)
ports.
•
Note that when LPS is enabled on an active port, all MAC addresses learned on that port prior to the
time LPS was enabled are cleared from the source learning MAC address table.
•
Configurable MAC learning restrictions consist of setting a source learning time limit window, speci-
fying a maximum number of MACs allowed on a specific port, configuring a list of MAC addresses
(individual or range of addresses) allowed on the port, and determining how a port handles traffic that
is unauthorized.
Examples
-> port-security 4/8 admin-status enable
-> port-security 2/1-10 admin-status enable
-> port-security 2/11-15 admin-status disable
-> port-security 4/3 admin-status locked
-> no port-security 1/1-12
-> port-security chassis disable
-> port-security chassis convert-to-static
Release History
Release 6.1; command was introduced.
Release 6.1.5; chassis parameter was added.
Release 6.4.4; admin-status, locked and convert-to-static parameters added.
Related Commands
port-security mac
port-security mac-range
port-security maximum
port-security shutdown
port-security violation
MIB Objects
learnedPortSecurityTable
lpsAdminStatus
OmniSwitch CLI Reference Guide
Configures a single authorized source MAC address for a port that
belongs to a specified VLAN.
Configures a list of authorized MAC addresses by defining a range of
addresses allowed on the port.
Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
Configures the amount of time in minutes to allow source learning on all
LPS ports.
Selects the method for handling traffic that does not comply with LPS
restrictions for the specified port(s).
June 2012 page 40-3