Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3239

Virtual Private LAN Service (VPLS) Commands
Usage Guidelines
•
To specify a SAP ID, use the slot/port and linkagg agg-num parameters combined with the :0, :qtag,
or :all parameters. For example, enter 1/2:all to specify the SAP on access port 1/2 that maps all traf-
fic to this service that is not already mapped to other SAPs.
•
Use the no trusted form of this command with the priority value parameter to configure a priority
value to assign to packets ingressing on the SAP.
•
Administratively disabling the SAP is not required to change the trust mode for the SAP.
•
When the trust mode is changed from untrusted to trusted, the priority value is automatically set to the
default best effort priority value (zero).
•
Note that untagged Layer 2 control packets (for example, BPDU, GVRP, and AMAP) are always
tunneled (if enabled) through the MPLS cloud with the default EXP bits set to 7, so that they can arrive
at the destination router at the highest COS queue of 7. As a result, trusted and untrusted SAPs config-
ured on the access ports will not affect the Layer 2 control packets ingressing on the access ports.
•
Configuring the trust mode on an access port is not allowed. These settings are configured for the SAP
to which the access port is associated.
Examples
-> configure service vpls 10 sap 1/2:10 trusted
-> configure service vpls 13 linkagg 20 trusted
-> configure service vpls 10 sap 1/2:10 no trusted priority 7
-> configure service vpls 13 linkagg 20 no trusted priority 3
Release History
Release 6.4.2; command was introduced.
Related Commands
configure service vpls sap create
configure service vpls sap description
configure service vpls sap shutdown
configure service vpls sap static-mac
show service id sap
show service sap-using
MIB Objects
alaSapExtraInfoTable
alaSapInfoTrusted
alaSapInfoPriority
OmniSwitch CLI Reference Guide
Configures a SAP by associating a SAP ID with a Virtual Private
LAN Service (VPLS).
Configures a description for the specified SAP ID.
Configures the administrative status for the specified SAP ID.
Configures a static MAC address entry in the forwarding data-
base for the service that is associated with the specified SAP ID.
Displays configuration information about the Service Access
Points (SAPs) associated with the specified service.
Displays the SAP configuration for the local router.
June 2012 page 50-65