Configure Router Mpls Interface Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MPLS Static LSP and FRR Commands

configure router mpls interface shutdown

Configures the administrative status for specified MPLS interface.
configure router mpls interface ip-intf-name {no shutdown | shutdown}
Syntax Definitions
ip-intf-name
no shutdown
shutdown
Defaults
By default, the administrative status of an MPLS interface is enabled.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Disabling the administrative status for an MPLS interface does not remove the MPLS configuration
from that interface. However, any Label Switched Paths (LSPs) associated with the MPLS interface are
also administratively disabled.
•
When a disabled MPLS interface is enabled, any associated LSPs are also enabled.
•
The MPLS interface name specified with this command must already exist in the router configuration.
Examples
-> configure router mpls interface vlan-20 no shutdown
-> configure router mpls interface vlan-20 shutdown
Release History
Release 6.4.2; command was introduced.
Related Commands
configure router mpls interface
show router mpls interface
MIB Objects
vRtrMplsIfTable
vRtrMplsIfAdminState
OmniSwitch CLI Reference Guide
The name of an existing MPLS IP interface.
Enables the MPLS administrative status for the interface.
Disables the MPLS administrative status for the interface.
Configures MPLS support on an IP interface.
Displays the MPLS interface configuration.
June 2012 page 49-5