User Lockout-Duration - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

AAA Commands

user lockout-duration

Configures the length of time a user account remains locked out of the switch. At the end of this time
period, the user account is automatically unlocked.
user lockout-duration minutes
Syntax Definitions
minutes
Defaults
parameter
minutes
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is only available to the admin user because the admin user account is the only account
protected from any type of lockout attempt.
•
Note that if the lockout duration time period is set to zero (the default), then locked user accounts are
never automatically unlocked.
•
Only the admin user or a user with read/write AAA privileges can unlock a locked user account when
the lockout duration time is set to zero. An account is unlocked by changing the user password or with
the user lockout unlock
•
Do not configure a lockout duration time period that is less than the amount of time configured for the
observation window.
•
The lockout duration time period is a global lockout setting that is applied to all passwords configured
on the switch.
•
Lockout settings are saved automatically; that is, these settings do not require the
configuration snapshot
Examples
-> user lockout-duration 60
-> user lockout-duration 0
Release History
Release 6.3.1; command was introduced.
OmniSwitch CLI Reference Guide
The number of minutes the user account remains locked out. The range
is 0 to 99999.
default
0
command.
command to save user settings over a reboot.
June 2012
write memory or
page 36-69