Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2584

sha+des
md5+des
name
console-only enable
console-only disable
Defaults
By default, if a user is created without indicating the read and write privileges and SNMP access, the user
will be given privileges based on the default user account. The default user account may be modified, but
by default it has the following privileges:
parameter
read-only | read-write
no snmp | no auth | sha | md5 |
sha+des | md5+des
console-only
For more information about the default user account, see the OmniSwitch AOS Release 6 Switch Manage-
ment Guide.
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
In addition to the syntax listed for the command, the syntax authkey key will display in an ASCII text
file produced via the snapshot command if the user is allowed SNMPv3 access to the switch.The
authentication key is in hexadecimal form, and is deducted from the user's password with SHA or
MD5 hash and encrypted with DES encryption. The key parameter only appears in configuration files
that are resulting from a snapshot. The key is computed by the switch based on the user's SNMP access
and will only appear in the ASCII text file; it is not displayed through the CLI. (This key is used for
both Auth Password and Priv Password in the OmniVista NMS application.)
•
At least one user with SHA/MD5 authentication and/or DES encryption must be configured on the
switch for SNMPv3 communication with OmniVista.
•
Use user username and password password to reset a user's password configured through the pass-
word command.
•
Typically the password should be a string of non-repeating characters. The CLI uses the first occur-
rence of the character series to uniquely identify the password. For example, the password tpubtpub is
the same as tpub. A better password might be tpub345.
page 36-50
Specifies that the SHA authentication algorithm and DES encryption
standard should be used for authenticating and encrypting SNMP PDU
for the user.
Specifies that the MD5 authentication algorithm and the DES encryp-
tion standard should be used for authenticating and encrypting SNMP
PDU for the user.
The name of an end-user profile associated with this user. Configured
through the end-user profile
user if command families/domains are associated with the user.
Enables console only access for the user admin.
Disables console only access for the user admin.
default
read-only
no snmp
disable
command. Cannot be associated with the
OmniSwitch CLI Reference Guide
AAA Commands
June 2012