Netsec Group Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

netsec group port

Creates a monitoring-group and configures port associations for that group.
netsec group grp_name port slot/port[-port2]
no netsec group grp_name port slot/port[-port2]
Syntax Definitions
grp_name
slot/port
port2
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a port or a range of ports from the monitoring-group.
•
A port-range cannot be a subset of any other port-range which is already configured.
•
The word 'all' cannot be used as a group name (grp_name).
Examples
-> netsec group ad-port port 1/1
-> netsec group ad-port port 1/3-10
-> no netsec group ad-port port 1/1
Release History
Release 6.3.1; command was introduced.
Related Commands
netsec group anomaly
show netsec summary
page 38-2
The name of the monitoring-group (up to 32 characters).
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to associate on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Configures the monitoring period of an anomaly for a port-group,
packet count configuration for triggering anomaly detection, anomaly
detection algorithm's sensitivity to discrepancy in standard and
observed traffic pattern.
Displays the anomaly check summary.
Network Security Commands
OmniSwitch CLI Reference Guide June 2012