Show Router Ldp Bindings Fec-Type - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show router ldp bindings fec-type

Displays the LDP bindings for a specific type of Forwarding Equivalence Class (FEC) or for a specific
service FEC number.
show router ldp bindings fec-type {fec-number | services | prefixes} [session ip-address[:label-space]]
Syntax Definitions
services
prefixes
fec-number
ip-address
:label-space
Defaults
By default, LDP bindings are displayed for all LDP sessions associated with the specified FEC type.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Specify an FEC number to display label binding information for a specific FEC.
•
Use the services parameter to display label binding information for service FECs. Note that only VPLS
is supported.
•
Use the prefixes parameter to display label binding information for address FECs. These are FECs that
are associated with an IP address, instead of a service.
•
Use the session parameter to display label binding information for a specific LDP router session. Note
that entering a label-space value is optional with this parameter.
Examples
->show router ldp bindings fec-type 128
LDP LSR ID: 10.10.10.5
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up,
E = Epipe Service, V = VPLS Service, M = Mirror Service,
A = Apipe Service, F = Fpipe Service, I = IES Service, R = VPRN service,
P - Ipipe Service
TLV = (Type, Length: Value)
page 48-36
Displays bindings for service FECs.
Displays bindings for address FECs.
The service FEC number. Valid numbers are 128 and 129.
The LDP router ID (Loopback0 IP address configured for the switch)
for a specific LDP session.
The label space ID number that the router advertises on the LDP inter-
face. This value is appended to the LDP router ID address. The valid
range is 0–65535.
D = Status Signaled Down,
MPLS LDP Commands
OmniSwitch CLI Reference Guide June 2012