Show Efm-Oam Port Detail - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

LINK OAM Commands

show efm-oam port detail

Displays the LINK OAM configuration and other related parameters for a port.
show efm-oam port slot/port detail
Syntax Definitions
slot/port
Defaults
N/A.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855.
Usage Guidelines
Use this command when you want to get LINK OAM configuration details for a specific port.
Examples
-> show efm-oam port 1/1 detail
OAM Status
Operational Status
Mode
Max OamPDU size
Config Revision
Functions Supported
Loopback Status
Loopback Rx Status
Max OamPDUs
KeepAlive Interval(seconds)
Hello Interval(seconds)
Dying Gasp Notify Status
Critical Event Notify Status : enable
Link Monitoring
------------------+------------+-------------+------------+---------------
errored-frame
errored-frame-period
errored-frame-seconds-summary
Output fields are described here:
output definitions
OAM Status
Operational Status
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
: enable,
: activeSendLocal,
: active,
: 1518,
: 0,
: loopback,event notification,
: noLoopback,
: ignore,
: 10,
: 10,
: 5,
: enable,
Window
10 dsec
2000000 frames
600 dsec
The state of LINK OAM on the port.
The state of the port in discovering whether the peer has LINK OAM
capability or not.
June 2012
Threshold Notify
(errors) Status
10 frames enable
10 frames enable
1 framesec enable
page 46-31