Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2654

output definitions (continued)
Account lockout
Password bad attempts
Read Only for domains
Read/Write for domains
Read Only for families
Read/Write for families
END user profile
Snmp allowed
Snmp authentication
Snmp encryption
Console-Only
Possible values for command domains and families are listed here:
Domain
domain-admin
domain-system
domain-physical
domain-network
domain-layer2
domain-service
domain-policy
domain-security
page 36-120
Indicates if the user account is locked out (Yes or No) and how many
minutes remain until the user account is automatically unlocked. If no
remaining time is displayed, the admin user or a user with admin privi-
leges must manually unlock the account. Configured through the
lockout-duration and user lockout unlock
The number of failed password login attempts for this user account.
The command domains available with the user's read-only access. See
the table on the next page for a listing of valid domains. This field does
not display if an end-user profile is associated with the user account.
The command domains available with the user's read-write access. See
the table on the next page for a listing of valid domains. This field does
not display if an end-user profile is associated with the user account.
The command families available with the user's read-only access. See
the table on the next page for a listing of valid families. This field does
not display if an end-user profile is associated with the user account.
The command families available with the user's read-write access. See
the table on the next page for a listing of valid families. This field does
not display if an end-user profile is associated with the user account.
The name of an end-user profile associated with the user account. Con-
figured through the end-user profile
plays if an end-user profile is associated with the user account.
Indicates whether or not the user is authorized to use SNMP (YES or
NO). SNMP is allowed for the user account when SNMP authentica-
tion is specified for the account.
The level of SNMP authentication, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
The level of SNMP encryption, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
Displays whether the ability for the admin user to access the switch
using only the console connection is enabled or disabled.
Corresponding Families
file telnet dshell debug
system aip snmp rmon webmgt config
chassis module interface pmm health
ip rip ospf bgp vrrp ip-routing ipx ipmr ipms
vlan bridge stp 802.1q linkagg ip-helper
dns
qos policy slb
session avlan aaa
commands.
command. This field only dis-
OmniSwitch CLI Reference Guide
AAA Commands
user
June 2012