Show Efm-Oam Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

LINK OAM Commands

show efm-oam port

Displays the status of LINK OAM on all the ports in the system, along with other relevant information
such as OAM mode, operational status and loopback status of the port.
show efm-oam port [slot/port1-port2] [enable | disable] [active | passive]
Syntax Definitions
slot/port1
-port2
enable
disable
active
passive
Defaults
By default, displays the LINK OAM status on all ports.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855.
Usage Guidelines
Use this command to display the state of LINK OAM on the basis of enabled or disabled port and on the
basis of active or passive port.
Examples
-> show efm-oam port
Port EFM-OAM Status
-------+----------------+---------+-------------------+----------------
1/1
1/2
1/3
1/4
1/5
1/6
1/7
-> show efm-oam port 1/1-5
Port EFM-OAM Status
-------+----------------+---------+-------------------+----------------
1/1
1/2
1/3
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g. 3/1-4 specifies ports 1,2,3, and 4 on slot 3).
Specifies whether to display the LINK OAM enabled ports.
Specifies whether to display the LINK OAM disabled ports.
Specifies whether to display the LINK OAM active ports.
Specifies whether to display the LINK OAM passive ports.
Mode Operational Status
enabled active
disabled active
enabled passive
disabled active
disabled active
disabled active
disabled active
Mode Operational Status
enabled active
disabled active
enabled passive
June 2012
Loopback Status
operational
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
Loopback Status
operational
activeSendLocal
activeSendLocal
remoteLoopback
noLoopback
noLoopback
noLoopback
noLoopback
noLoopback
noLoopback
remoteLoopback
noLoopback
noLoopback
page 46-27