configure service port l2profile
Assigns an existing Layer 2 profile to the specified service access port. This profile determines how Layer
2 protocol frames ingressing on the access port are processed.
configure service port {slot/port | linkagg agg_num} l2profile {default | profile-name}
Syntax Definitions
slot/port1
agg_num
default
profile-name
Defaults
By default, the default Layer 2 profile (def-access-profile) is assigned when a port is configured as a
service access port.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to revert the associated profile back to the default profile.
•
Specify only ports or link aggregates that are configured as service access ports. This command does
not apply to network ports.
•
Specify a profile name that already exists in the router configuration.
Examples
-> configure service port 1/3 l2profile sap_1_profile
-> configure service port linkagg 10 l2profile sap_1_profile
-> configure service port 1/3 l2profile default
-> configure service port linkagg 10 l2profile default
Release History
Release 6.4.2; command was introduced.
page 50-56
The slot and port number of the service access port.
The link aggregate ID number (0–31) of a service access link aggregate.
Assigns the default profile to the specified port.
The name of an existing Layer 2 profile.
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide
June 2012