Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3114

Local Cfg Seq No:
->show router ldp discovery peer 10.11.0.6 state down
Interface Name
--------------------------------+---------------+---------------+-------+------
No Matching Entries Found
->show router ldp discovery peer 10.11.0.6 state established
Interface Name
--------------------------------+---------------+---------------+-------+------
vlan-30
No. of Hello Adjacencies: 1
->show router ldp discovery peer 10.11.0.6 state trying
Interface Name
--------------------------------+---------------+---------------+-------+------
No Matching Entries Found
output definitions
Interface Name
Local Addr
Peer Addr
AdjType
State
No. of Hello Adjacencies
Up Time
Hold Time Remaining
Hello Mesg Recv
Hello Mesg Sent
Local IP Address
Remote IP Address
Local Hello Timeout
Remote Hello Timeout
Local Cfg Seq No
Remote Cfg Seq No
page 48-58
3,
Local Addr Peer Addr
Local Addr Peer Addr
10.11.0.6
Local Addr Peer Addr
The name of the local LDP IP interface.
The IP address of the local router.
The IP address of the LDP peer.
The type of adjacency between the local LDP interface and the LDP
peer (Link–peers directly connected establish linked sessions or Targ–
peers not directly connected establish targeted sessions).
The status of the LDP hello adjacency (Estab, Trying, or Down).
The number of LDP hello adjacencies discovered.
The amount of time the adjacency has been established.
The amount of time left before the peer for this adjacency is declared
down.
The number of Hello messages received from this adjacency.
The number of Hello messages sent for this adjacency.
The IP address of the local IP interface for this adjacency.
The IP address of the peer IP interface for this adjacency.
The Hello Timeout value configured for the local router.
The Hello Timeout value configured for the peer.
The configuration sequence number that was in the Hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
The configuration sequence number that was in the Hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
Remote Cfg Seq No:
AdjType State
AdjType State
10.10.0.7 Link
AdjType State
OmniSwitch CLI Reference Guide
MPLS LDP Commands
3
Estab
June 2012