Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3120

->show router ldp interface vlan-30
LDP Interfaces
Interface
--------------------------------+---+----+------+-----+------+-------+---------
vlan-30
No. of Interfaces: 1
->show router ldp interface vlan-30 detail
LDP Interfaces (Detail)
Interface "vlan-30"
Admin State:
Hold Time:
Keepalive Timeout:
Transport Addr:
23:14:27,
Active Adjacencies:
Tunneling:
Lsp Name
->show router ldp interface 10.11.0.66
LDP Interfaces
Interface
--------------------------------+---+----+------+-----+------+-------+---------
vlan-30
No. of Interfaces: 1
output definitions
Interface
Adm
Opr
Hello Factor
Hold Time
KA Factor
page 48-64
Adm Opr Hello
Factor Time
Up Up 3
Up,
15,
30,
System,
1,
Disabled,
: None
Adm Opr Hello
Factor Time
Up Up 3
The name of the local LDP IP interface. Configured through the
configure router ldp interface-parameters interface
The administrative state of the LDP interface (Up or Down). Config-
ured through the configure router ldp interface-parameters inter-
face shutdown command.
The operational state of the LDP interface (Up or Down).
The Hello factor value that is divided into the Hold Time value to
determine the interval at which Hello messages are sent from this inter-
face. Configured through the
ters hello command.
The Hold Time value (also referred to as Hello Timeout) determines
the amount of time, in seconds, LDP waits to receive hello messages
from a peer before declaring that the peer is down. Configured through
the configure router ldp interface-parameters hello
The Keepalive Factor value. This value is divided into the Keepalive
Timeout value to determine the interval at which Keepalive messages
are sent from this interface. Configured through the
ldp interface-parameters keepalive
Hold KA KA
Factor Timeout Address
15 3 30
Oper State: Up,
Hello Factor: 3,
Keepalive Factor: 3,
Last Modified:
Hold KA KA
Factor Timeout Address
15 3 30
configure router ldp interface-parame-
command.
OmniSwitch CLI Reference Guide
MPLS LDP Commands
Transport
System
05/26/2009
Transport
System
command.
command.
configure router
June 2012