Avlan Auth-Ip - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

avlan auth-ip

Configures an IP address to be used for VLAN authentication.
avlan vlan_id auth-ip ip_address
Syntax Definitions
vlan_id
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
If an IP address is not configured for an Authenticated VLAN, the switch automatically configures the
address with an authentication address based on the router port address (x.x.x.253).
•
The IP address of the Authenticated VLAN must have the same mask as the router port address. For
example, if the router port address of the Authenticated VLAN is 10.10.2.4, then the IP address must
be 10.10.2.x.
•
When modifying the authentication address for a specific VLAN, make sure that the new address does
not match an IP router interface address for the same VLAN. IP address resolution problems can occur
if these two addresses are not unique.
•
VLANs are set up for authentication through the
Examples
-> avlan 3 auth-ip 10.10.2.4
Release History
Release 6.1; command was introduced.
page 36-46
The ID of the Authenticated VLAN.
The IP address to be used for authentication on this VLAN. The IP
address must have the same mask as the router port address for the
Authenticated VLAN.
vlan authentication command.
OmniSwitch CLI Reference Guide
AAA Commands
June 2012