Aaa Authentication Vlan Single-Mode - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

AAA Commands

aaa authentication vlan single-mode

Specifies the AAA servers to be used in single-authority mode for Authenticated VLANs.
aaa authentication vlan single-mode server1 [server2] [server3] [server4]
no aaa authentication vlan
Syntax Definitions
server1
server2...server4
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to disable Authenticated VLANs in single mode.
•
The servers may be RADIUS, TACACS+, or LDAP servers. Up to 4 servers (total) may be configured
in single mode. Each server name should be separated by a space.
•
The switch uses only the first available server in the list to check for user information. For example, if
server1 is not available, the switch will poll server2. If user information is not found on the first avail-
able server, the authentication request will fail.
•
RADIUS, TACACS+, and LDAP servers may each have an additional backup specified through the
aaa radius-server,
Examples
-> aaa authentication vlan single-mode pubs1 pubs2 pubs3
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the RADIUS, TACACS+, or LDAP authentication server
used for authenticating users through all Authenticated VLANs on the
switch. At least one server is required. RADIUS, TACACS+, and
LDAP server names are set up through the
aaa tacacs+-server, and
The names of backup servers for authenticating users through Authenti-
cated VLANs. Up to 3 backups may be specified; include a space
between each server name. These backups are only used if
server_name1 becomes unavailable. They are polled in the order they
are listed in this command. The first available server becomes the
authentication server.
aaa tacacs+-server, and
June 2012
aaa ldap-server
aaa ldap-server commands.
aaa radius-server,
commands.
page 36-15