Ethoam Endpoint Ccm - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam endpoint ccm

Configures the MEP to generate Continuity Check Messages (CCM).
ethoam endpoint mep_id domain {md_name | mac_address} association ma_name
ccm {enable | disable}
Syntax Definitions
mep_id
md_name
mac_address
ma_name
enable
disable
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
Examples
-> ethoam endpoint 100 domain MD association MA ccm enable
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; mac_address parameter added.
Related Commands
show ethoam domain
association end-point
OmniSwitch CLI Reference Guide
Specifies the Maintenance Association End Point. The valid range is
1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
Specifies the CFM system MAC address.
Name of the Ethernet OAM association. Up to 48 (minus the domain
name length) characters may be used.
Enables MEP to generate CCM
Disables MEP to generate CCMs
Displays the information of a specific MEP in a Management
Domain configured on the bridge.
June 2012
ethoam domain.
s.
.
page 45-31