Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3277

Virtual Private LAN Service (VPLS) Commands
-> show service sdp-using far-end 10.11.0.5
Service Destination Point(Far-End : 10.11.0.6)
SvcId SdpId
-----------+-------------------+-------+--------------+------+--------+--------
100 10:100
Number of SDPs : 1
output definitions
SvcId
SDP Id
Type
Far End
Oper S
I. Label
E. Label
Release History
Release 6.4.2; command was introduced.
Related Commands
show service id all
show service id labels
show service id sdp
show service sdp
MIB Objects
OmniSwitch CLI Reference Guide
Type Far End
Mesh 10.11.0.6
The service ID associated with the SDP. Configured through the
configure service vpls create
the configure service vpls mesh-sdp
The SDP identifier comprised of the SDP ID number, the service ID
number, and the IP address of the far-end router for this SDP tunnel.
For example, 10:100 identifies SDP 10 bound to VPLS 100 with the
tunnel endpoint at router 10.11.0.6.
The SDP binding type (mesh or spoke) for this service. The spoke
binding type is not supported. Configured through the
vice vpls mesh-sdp
The IP address of the remote end of the MPLS tunnel defined by this
SDP. Configured through the
mand.
The operational state of this SDP (Up or Down).
The VC label used by the far-end device to send packets to the local
device for this SDP binding.
The VC label used by the local device to send packets to the far-end
device for SDP binding.
Displays the detailed configuration for the specified service ID, includ-
ing all SDPs and SAPs associated with the service.
Displays a list of all labels that the specified service is using.
Displays configuration information for the Service Distribution Points
(SDPs) associated with the specified service.
Displays the SDP configuration for the switch.
June 2012
Opr I.Label
Up 131069
command and bound to the SAP using
command.
command.
configure service sdp far-end
E.Label
131070
configure ser-
com-
page 50-103