Show Router Ldp Bindings Service-Id - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show router ldp bindings service-id

Displays the LDP bindings for the specified service.
show router ldp bindings service-id service-id
Syntax Definitions
service-id
Defaults
N/A.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
The service ID is a unique number that identifies a specific service. All LDP bindings associated with the
service ID are displayed.
Examples
# show router ldp bindings service-id 100
LDP LSR ID: 10.11.0.6
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up,
R = VPRN Service, V = VPLS Service, W = VPWS Service
TLV = (Type, Length: Value)
LDP Service FEC 128 Bindings
Type VCId
------+----------+----------+------+---------------+-------+-------+-----+-----
V-Eth 100
No. of VC Labels: 1
LDP Service FEC 129 Bindings
AGI
Type
------+----------+----------+------+---------------+-------+-------+-----+-----
No. of FEC 129s: 1
output definitions
Type
VCId
page 48-52
The service ID number. The valid range is 1–2147483647.
D = Status Signaled Down,
SvcId SDPId Peer
100 10 10.11.0.66
SAII
SvcId SDPId Peer
The type of service (V-Eth) exchanging labels through the Service
Distribution Point (SDP).
The virtual connection (VC) ID number used by each end of the SDP
tunnel to identify the VC.
MPLS LDP Commands
IngLbl EgrLbl LMTU
131068U 131068 1500
TAII
IngLbl EgrLbl LMTU
OmniSwitch CLI Reference Guide
RMTU
1500
RMTU
June 2012