Health Threshold - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

health threshold

Configures thresholds for input traffic (RX), output/input traffic (TX/RX), memory usage, CPU usage, and
chassis temperature.
Input traffic, output/input traffic, memory usage, and CPU usage thresholds specify the maximum percent-
age for each resource that may be consumed before a trap is sent to the user. The temperature threshold
specifies the maximum operating temperature, in Celsius, allowed within the chassis before a trap is sent.
health threshold {rx percent | txrx percent | memory percent | cpu percent | temperature degrees}
Syntax Definitions
rx
txrx
memory
cpu
percent
temperature
degrees
Defaults
parameter
percentage
degrees
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When a resource falls back below the configured threshold, an additional trap is sent to the user. This
indicates that the resource is no longer operating beyond its configured threshold limit.
•
Changing a threshold value sets the value for all levels of the switch (i.e., switch, module, and port).
You cannot set different threshold values for each level.
•
For detailed information on each threshold type, refer to
Problems" chapter in the OmniSwitch AOS Release 6 Network Configuration Guide.
•
To view the current health threshold values, use the
show temperature
commands are unrelated.
page 52-2
Specifies the maximum input (RX) traffic threshold.
Specifies the maximum output/input (TX/RX) traffic threshold.
Specifies the maximum RAM memory usage threshold.
Specifies the maximum CPU usage threshold.
The new threshold value, in percent, for the corresponding resource—
i.e., rx, txrx, memory, cpu—(0–100).
Specifies the temperature threshold for the chassis.
The new threshold value, in Celsius, for the chassis temperature
threshold (0–100).
default
80
50
command as it does not display health threshold statistics. These two show
Health Monitoring Commands
page 52-6, or refer to the "Diagnosing Switch
show health threshold command. Do not use the
OmniSwitch CLI Reference Guide June 2012