Show Service Sap-Using - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service sap-using

Displays the Service Access Point (SAP) configuration for the local router.
show service sap-using [sap {slot/port | linkagg agg_num}] [:0 | :all | :qtag1]
Syntax Definitions
slot/port1
agg_num
:0
:all
:qtag1
Defaults
By default, a list of all SAPs configured for the router is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
To display detailed information for an individual SAP, specify a SAP ID using the slot/port and linkagg
agg-num parameters combined with the :0, :qtag, or :all parameters. For example, enter 1/2:all to display
information for the SAP on access port 1/2 that maps all traffic that is not classified into other SAPs to this
service.
Examples
-> show service sap-using
Service Access Points
PortId
-------------------+----------+----+----+-------+---
1/2:100
1/2:110
1/2:all
1/11:200
8/8:300
1/3
0/5:400
page 50-100
The slot and port number of the service access port.
The link aggregate ID number (0–31) of a service access link aggregate.
Specifies no (null) encapsulation value for the SAP. Depending on the
pre-configured encapsulation type for the access port, a SAP using a
null encapsulation will direct tagged and untagged or only untagged
traffic to the associated service.
Specifies a wildcard SAP. All 802.1q-tagged or untagged traffic that is
not classified into another SAP is mapped to the wildcard SAP. Not
configurable on null encapsulation access ports.
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
SvcId Adm Opr
100 Up Down Yes
100 Up Down Yes
100 Up Down Yes
100 Up Up
100 Up Up
200 Up Up
200 Up Up
Virtual Private LAN Service (VPLS) Commands
Trusted Pri
0
0
0
Yes 0
Yes 0
Yes 0
Yes 0
OmniSwitch CLI Reference Guide June 2012