Show Policy Map Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

show policy map group

Displays information about pending and applied policy map groups.
show [applied] policy map group [group_name]
Syntax Definitions
applied
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Information for all policy map groups displays unless group_name is specified.
•
The display may include any of the following characters:
character definition
+ Indicates a new policy port group.
- Indicates the policy port group is pending deletion.
# Indicates that the policy port group differs between
the pending/applied port groups.
Examples
-> show policy map group
Group Name
+tosGroup
output definitions
Group Name
From
Entries
OmniSwitch CLI Reference Guide
Indicates that only map groups that have been applied should be
displayed.
The name of the policy map group for which you want to display infor-
mation; or a wildcard sequence of characters for displaying information
about map groups with similar names. Use an asterisk (*) to indicate a
wildcard character.
From Entries
cli 1-2:4
4:5
The name of the map group, configured through the policy map group
command.
The origin of the port group: cli indicates that the entry was configured
on the switch; ldap indicates the entry was configured through Policy-
View.
The slot/port combinations associated with the port group.
June 2012 page 33-215