Sflow Receiver - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

sflow receiver

Sets the destination hosts where the sFlow datagrams are sent out. If there are multiple destinations, then
each destination is associated with the receiver instance. All these destinations are attached to the sFlow
manager instance and to an associated sampler/poller.
sflow receiver num name string timeout {seconds | forever} address {ip_address | ipv6address} udp-
port port packet-size size Version num
sflow receiver receiver_index release
Syntax Definitions
num
string
seconds | forever
ip_address| ipv6address
port
size
num
Defaults
parameter
string
seconds
ip_address
port
size
version num
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the release form at the end of the command to delete a receiver.
Examples
-> sflow receiver 1 name Golden address 198.206.181.3
-> sflow receiver 1 release
page 42-4
Specifies the receiver index.
Specifies the name.
Specifies the timeout value.
Specifies the 32/128-bit ip address.
Specifies the UDP (destination) port.
Specifies the maximum number of data bytes (size) that can be sent.
Specifies the version number.
default
empty
0
0.0.0.0(ipv4)
6343
1400
5
OmniSwitch CLI Reference Guide
sFlow Commands
June 2012