Service Assurance Agent Commands
show saa
Displays SAA configuration information.
show saa [string | {descr description}]
Syntax Definitions
string
description
Defaults
By default, information is displayed for all configured SAAs.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the string or description parameter to display information for a specific SAA.
Examples
-> show saa saa31
Legend: eth-lb = ethoam-loopback
: eth-dmm = ethoam-two-way-delay
SAA
Type
Status Interval(Min.)Time of Last-Run Last-Run Result Description
-----+------+-------+---------------+----------------+-------------+----------
Saa31 ip-ping started
-> show saa
Legend: eth-lb = ethoam-loopback
: eth-dmm = ethoam-two-way-delay
SAA
Type
Status
-----+-------+--------+------------+------------------+---------------+-----------
Saa20 ip-ping started
Saa31 ip-ping started
Saa89
ip-ping stopped 180
Saa90
eth-lb stopped
Saa95
eth-lb stopped
Saa98
eth-dmm stopped 120
Saa99
eth-dmm started200
Release History
Release 6.4.3; command was introduced.
OmniSwitch CLI Reference Guide
An existing SAA ID string.
An existing SAA description string.
180
2010-01-12,21:30:05.0
Interval(Min.)Time of Last-Run
130
2010-01-15,09:31:53.0
180
2010-01-12,21:30:05.0
2010-01-12,09:45:00.0
150
NOT RUN
300
2010-01-16,11:31:53.0
NOT RUN
2010-01-16,15:20:05.0
June 2012
failed
Datacenter1
Last-Run Result
Description
success
DEFAULT
failed
Datacenter1
success
Datacenter5
undetermined Ethernet LB
success
Ethernet LB1
failed
DEFAULT
success
Two way test
page 47-15