Port Mirroring Source Destination - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

port mirroring source destination

Defines a port to mirror and the port that is to receive data from the mirrored port, and enables or disables
port mirroring status. Also, enables or diables remote port mirroring.
port mirroring port_mirror_sessionid [no] source slot/port[-port2] [slot/port[-port2]...]
destination slot/port [rpmir-vlan vlan_id] [bidirectional |inport |outport] [unblocked vlan_id]
[enable | disable]
Syntax Definitions
port_mirror_sessionid
source
no source
slot
port
port2
[slot/port[-port2]...]
rpmir-vlan vlan_id
bidirectional
inport
outport
vlan_id
enable
disable
Defaults
parameter
bidirectional | inport | outport bidirectional
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The maximum number of mirroring sessions is limited to two on OmniSwitch 6850 and 6855
page 41-2
Mirroring session identifier.
Adds the alphabet "a" to a port mirroring session.
Removes a port or range of ports from a port mirroring session.
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Configures multiple source ports.
Reserved VLAN (1–4094) to carry the mirroring traffic.
Specifies bidirectional port mirroring.
Specifies incoming unidirectional port mirroring.
Specifies outgoing unidirectional port mirroring.
VLAN ID is the number (1–4094) that specifies the VLAN to protect
from Spanning Tree changes while port mirroring/monitoring is active.
Ports in this VLAN will remain unblocked.
Enables port mirroring status.
Disables port mirroring status.
default
enable
Port Mirroring and Monitoring Commands
OmniSwitch CLI Reference Guide June 2012