Show Policy Classify Tos - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

show policy classify tos

Specifies a ToS value for a hypothetical packet to show how the QoS software in the switch will handle
the packet.
show policy classify {l2 | l3 | multicast} [applied] tos tos_value
Syntax Definitions
l2
l3
multicast
applied
tos_value
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
•
If a ToS value is specified, a DSCP value may not be specified.
Examples
-> show policy classify l3 tos 7
See the output example given on
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The Type of Service bits value included in the IP header. The three most
significant bits of the byte determine the precedence (i.e, priority) of the
frame (0 is the lowest, 7 is the highest).
page 33-167 for more information about the potential screen display.
June 2012 page 33-193