Virtual Private LAN Service (VPLS) Commands
configure service sdp adv-mtu-override
Enables or disables VC-type MTU override for the specified SDP. Use this command to override the
advertised VC MTU with the service MTU.
configure service sdp sdp-ip adv-mtu-override
configure service sdp sdp-ip no adv-mtu-override
Syntax Definitions
sdp-id
Defaults
By default, VC-type MTU override is disabled. The service MTU does not override the advertised VC
MTU.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to disable VC-type MTU override for the specified SDP.
•
When VC-type MTU override is enabled, the router signals a VC MTU equal to the service MTU
(includes the Layer 2 header). When disabled, the service MTU minus the Layer 2 header is adver-
tised. In the receive direction, either VC-type MTU is accepted.
Examples
-> configure service sdp 10 adv-mtu-override
-> configure service sdp 10 no adv-mtu-override
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
An existing SDP ID number.
June 2012
page 50-25