Configure Router Mpls Static-Lsp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router mpls static-lsp

Configures a static Label Switched Path (LSP) instance on an ingress Label Edge Router (LER).
configure router mpls static-lsp lsp-name
configure router mpls no static-lsp lsp-name
Syntax Definitions
lsp-name
Defaults
N/A
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
To remove this static LSP configuration from the ingress router, administratively disable (shutdown)
the LSP and then use the no form of this command to remove the configuration from the router.
•
The Static LSP instance is identified by the LSP name on the ingress router and by the MPLS interface
name and ingress label combination on both transit and egress routers.
•
Configuring the static LSP instance is done only on the ingress LER to identify the origination point of
the LSP.
•
Once the static LSP is created and associated with a name, configuring the destination IP address, the
push operation, and the next-hop router IP address for the LSP is required.
Examples
-> configure router mpls static-lsp to-R3
-> configure router mpls no static-lsp to-R3
Release History
Release 6.4.2; command was introduced.
Related Commands
configure router mpls static-lsp
shutdown
configure router mpls static-lsp
to
configure router mpls static-lsp
push next-hop
show router mpls static-lsp
page 49-14
An alphanumeric name, up to 32 characters, to assign to the static LSP.
Configures the administrative status of the static LSP.
Configures the destination System IP address for the static LSP.
Pushes the specified label on to the label stack and specifies the IP
address for the next-hop router in the static LSP.
Displays static LSP configuration information.
MPLS Static LSP and FRR Commands
OmniSwitch CLI Reference Guide June 2012