Reload - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

reload

Reboots the CMM to its startup software configuration.
reload [primary | secondary] [with-fabric] [in [hours:] minutes | at hour:minute [month day | day
month]]
reload [primary | secondary] [with-fabric] cancel
Syntax Definitions
primary | secondary
with-fabric
in [hours:] minutes
at hour:minute
month day | day month
cancel
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command causes the specified CMM to reboot. If no CMM is specified, the primary CMM
reboots.
•
The CPM, CFM and CPU of CMM can be reset independently.
•
If a reload command is issued and the local/remote fabric module is in up state, only the CPM will be
reset.
•
If a reload command is issued and the local/remote fabric module is in a down state, then the complete
CMM will be reloaded.
page 53-2
Reboot the primary or secondary CMM to its startup software
configuration. If the primary CMM is already running the startup
version, a primary reboot will result in a secondary takover.
Performs a complete CMM reload. This parameter is available only on
OmniSwitch chassis-based series switches.
Optional syntax. Schedules a reload of the software to take effect in the
specified minutes or hours and minutes within the next 24 hours.
Optional syntax. Schedules a reload of the software to take place at the
specified time using a 24-hour clock. If you do not specify the month
and day, the reload takes place at the specified time on the current day
provided the specified time is later than the time when the CLI
command is issued. If the specified time is earlier than the current time,
the reload will take place on the following day.
The name of the month and the number of the day for the scheduled
reload. Specify a month name and the day number. It is unimportant if
the month or day is first. See examples below for further explanation.
Cancels a pending time delayed reboot.
OmniSwitch CLI Reference Guide
CMM Commands
June 2012