MPLS LDP Commands
show router ldp interface
Displays the LDP interface configuration for the local router.
show router ldp interface [ip-intf-name | ip-address] [detail]
Syntax Definitions
ip-intf-name
ip-address
detail
Defaults
By default, the configuration for all LDP interfaces is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the ip-intf-name and ip-address parameters to display information for a specific interface.
•
Use the detail parameter to display additional information and statistics for LDP interfaces.
Examples
->show router ldp interface
LDP Interfaces
Interface
--------------------------------+---+----+------+-----+------+-------+---------
vlan-30
No. of Interfaces: 1
->show router ldp interface detail
LDP Interfaces (Detail)
Interface "vlan-30"
Admin State:
Hold Time:
Keepalive Timeout:
Transport Addr:
Active Adjacencies:
Tunneling:
Lsp Name
OmniSwitch CLI Reference Guide
The name of an existing LDP interface.
The IP address of an existing LDP interface.
Displays detailed adjacency information for the specified interface.
Adm Opr
Hello
Factor Time
Up
Up
3
Up,
15,
30,
System,
1,
Disabled,
: None
June 2012
Hold
KA
KA
Factor Timeout Address
15
3
30
Oper State:
Up,
Hello Factor:
3,
Keepalive Factor:
3,
Last Modified: 05/26/2009 23:14:27,
Transport
System
page 48-63