Aaa Radius Agent Preferred - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

AAA Commands

aaa radius agent preferred

Configures the source IP address field of the Radius packet.
aaa radius agent preferred {default | no-loopback | ip_address}
no aaa radius agent preferred
Syntax Definitions
default
no-loopback
ip_address
Defaults
By default, the radius agent setting is set to the default parameter.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When configuring a specific IP address, that address must already exist on the switch.
•
Use the no form of the command to clear a specific IP address and change the behavior back to
default.
Examples
-> aaa radius agent preferred 192.168.10.1
-> aaa radius agent preferred no-loopback
-> aaa radius agent preferred default
Release History
Release 6.3.4; command was introduced.
Release 6.4.3; command was deprecated, use
Related Commands
show aaa server
OmniSwitch CLI Reference Guide
The Loopback0 address, if configured, will be used for the source IP
address field. If no Loopback0 is configured, the first IP address on the
switch will be used.
The Loopback0 address should not be used for the source IP address
field and the first available IP address on the switch should be used for
this field.
The IP address to be used in the source IP field.
ip managed-interface.
Displays information about AAA servers.
June 2012 page 36-7