Show Rmon Events - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

RMON Commands

show rmon events

Displays RMON events (actions that take place based on alarm conditions detected by the RMON probe).
show rmon events [event-number]
Syntax Definitions
event-number
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
To display a list of logged events, omit the event-number from the command line.
•
To display statistics for a particular event, include the event-number in the command line.
•
The show rmon events command displays the following information for all RMON Logged Events:
Entry number, Time (hours/minutes/seconds) since the last change in status and Description (nature of
the event).
•
The show rmon events event-number command displays the following information for a particular
RMON Logged Event: Entry number, Time (hours/minutes/seconds) since the last change in status and
Description (nature of the event).
Examples
-> show rmon events
Entry
---------+-------------------+-----------------------------------------------------
1
2
-> show rmon events 2
Entry
---------+-------------------+-----------------------------------------------------
2
OmniSwitch CLI Reference Guide
The event number (optional) in the list of probes.
Time
00:08:00 etherStatsPkts.4008: [Falling trap] "Falling Event"
00:26:00 etherStatsCollisions.2008: "Rising Event"
Time
00:26:00 etherStatsCollisions.2008: "Rising Event"
June 2012
Description
Description
page 43-7