Show Service Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service port

Displays the access (customer-facing) port configuration for the router.
show service port [slot/port | linkagg agg_num]
Syntax Definitions
slot/port
agg-num
Defaults
By default, all service access ports are displayed if a port or link aggregate number is not specified.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the slot/port and linkagg agg-num parameters to display the configuration for a specific port or
link aggregate.
•
Access ports are required to configure a Service Access Point (SAP). A SAP is the point at which
customer traffic enters and exits the provider service. SAPs are not configured on network ports
Examples
-> show service port
Port Table
Port Admin
Id Status Status
-------+------+------+------+------+-----+-----+--------------------------------
8/7 Down Down
8/8 Up Up
8/9 Up Down
0/19 Up Up
Number of Ports : 4
-> show service port 8/9
Port Table
Port Admin
Id Status Status
-------+------+------+------+------+-----+-----+--------------------------------
8/9 Up Down
Number of Ports : 1
page 50-76
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The link aggregate ID number (0–31).
Link Cfg Oper
MTU MTU
1528 1528
9212 9212
9212 9212
9212 9212
Link Cfg Oper
MTU MTU
9212 9212
Virtual Private LAN Service (VPLS) Commands
Port Port L2Profile
Mode Encp
accs null def-access-profile
accs null DropBPDU
accs dotq Tunnel-Amap
accs null def-access-profile
Port Port L2Profile
Mode Encp
accs dotq Tunnel-Amap
OmniSwitch CLI Reference Guide June 2012