Configure Service Vpls Sap Description - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

configure service vpls sap description

Configures a description for the specified Service Access Point (SAP) ID. A SAP ID is comprised of a

customer-facing port (referred to as an access port) and an encapsulation value that is used to identify the

type of customer traffic to map to the associated service.

configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] description

configure service vpls service-id no sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] no description

Syntax Definitions

By default, a description is not added when the SAP is created.

:0 | :all | :qtag1

Platforms Supported

OmniSwitch 9000E

Usage Guidelines

To specify a SAP ID, use the slot/port and linkagg agg-num parameters combined with the :0, :qtag,

or :all parameters. For example, enter 1/2:all to specify the SAP on access port 1/2 that maps all traffic

to this service that is not already mapped to other SAPs.

Use the no form of this command to remove the description from the specified SAP.

An existing VPLS ID number.

The slot and port number of the service access port.

The link aggregate ID number (0–31) of a service access link aggregate.

Specifies a null encapsulation value for the SAP. Depending on the pre-

configured encapsulation type for the access port, a SAP using a null

encapsulation will direct tagged and untagged or only untagged traffic to

the associated service.

Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-

sified into another SAP is mapped to the wildcard SAP. Not config-

urable on null encapsulation access ports.

Specifies a VLAN ID tag for traffic ingressing on the access port. Only

traffic with this tag is mapped to this SAP. Not configurable on null

encapsulation access ports.

An ASCII text string up to 80 characters in length. Enclose special char-

acters, such as #, $, or spaces, in double quotation marks (for example

"CE1 to VPLS1 SAP").

Virtual Private LAN Service (VPLS) Commands

OmniSwitch CLI Reference Guide