Show Cmm - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show cmm

Displays basic hardware and status information for the CMM modules in a standalone switch or the
switches that perform the CMM role running in a stack.
show cmm [number]
Syntax Definitions
number
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E.
Usage Guidelines
•
On OmniSwitch chassis-based switches, a CMM installed in the left CMM slot position is defined as
CMM-A. A CMM installed in the right position is CMM-B. CMM modules on these switches are made
up of two subcomponents: the fabric board and the processor board. The fabric board is CMM
subcomponent 1; the processor board is subcomponent 2.
•
On OmniSwitch chassis-based switches, a CMM installed in the top CMM slot position is defined as
CMM-A. A CMM installed in the bottom position is CMM-B.
•
On OmniSwitch chassis-based switches, CMM information is displayed separately for each
subcomponent. For example, on OmniSwitch 9000E switches, CMM-A-1 refers to the fabric board of a
CMM installed in the left position; on OmniSwitch 9000E switches CMM-A-2 refers to the processor
board of the same CMM.
•
If a switch, which performs a secondary CMM role is installed and runs in a stack, the hardware and
status information for both the switches that perform the primary and secondary CMM role will be
displayed.
•
This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
page 54-36
Specifies the CMM slot number within a standalone switch or the CMM
switch number within a stack switches.
Chassis Management and Monitoring Commands
OmniSwitch CLI Reference Guide June 2012