Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2876

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

Not all of the protocol parameters are currently supported with the peer, tunnel, and discard parame-

ters. Use the following table to determine the parameter combinations that are supported:

Note that 802.3ad and 802.3ah control frames are processed the same. The 802.3ad parameter

specifies how both 802.3ad and 802.3ah control frames are to be processed on the UNI port.

Note that the VLAN Stacking provider edge (PE) switch will not tunnel GVRP frames unless the

GVRP feature and/or GVRP transparent switching functionality is enabled on the PE switch. This is

true even if GVRP processing is enabled for the VLAN Stacking port.

If a user-configured UNI profile is not associated with a UNI port, then the default profile

(default-uni-profile) is used to process control packets ingressing on the port.

-> ethernet-service uni-profile uni_1 l2-protocol stp gvrp discard

-> ethernet-service uni-profile uni_1 l2-protocol vrp mac-tunnel

-> ethernet-service uni-profile uni_config_tunnel_mac tunnel-mac 00:00:00:00:00:99

-> ethernet-service uni-profile uni_config_tunnel_mac l2-protocol gvrp mac-tunnel

-> no ethernet-service uni-profile uni_1

Release History

Release 6.3.1; command was introduced.

Release 6.4.3; tunnel-mac and mac-tunnel parameters were added.

OmniSwitch CLI Reference Guide

VLAN Stacking Commands