Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2477

802.1X Commands
re-authperiod seconds
reauthentication
no reauthentication
Defaults
parameter
both | in
force- authorized | force-
unauthorized | auto
quiet-period seconds
tx-period seconds
supp-timeout seconds
max_req
re-authperiod seconds
reauthentication | no
reauthentication
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
To set the port to accept any traffic without requiring 802.1X authentication, use the force-
authorized option.
•
Use the vlan port 802.1x
port.
•
Before any device is authenticated through an 802.1X port, the port will only process 802.1X frames
(EAPoL frames) from an unknown source.
•
Note that multiple devices can be authenticated on a given 802.1X port. Each device MAC address
received on the port is authenticated and learned separately. Only those that authenticate successfully
are allowed on the port, as described above. Those that fail authentication are blocked from accessing
the 802.1X port.
Examples
-> 802.1x port 3/1 quiet-period 30
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The amount of time that must expire before the switch requires re-
authentication of the Supplicant on this port. Only applicable when re-
authentication is enabled.
Specifies that the port will be reauthenticated after the re-authperiod
timer expires.
Specifies that the port will not be reauthenticated unless the
802.1x re-authenticate
default
both
auto
60
30
30
2
3600
no reauthentication
command with the disable option to disable 802.1X authentication on the
June 2012
command is entered.
page 35-3