Show Ethoam Linktrace-Reply - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

show ethoam linktrace-reply

Displays the content of the Linktrace reply (LTR) returned by a previously transmitted LTM. This
command displays the LTR based on the transaction identifier or sequence number of the LTM for which
the LTR is to be displayed.
show ethoam linktrace-reply domain d-name association a-name endpoint s-mepid tran-id num
Syntax Definitions
d-name
a-name
s-mepid
num
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
"LTM operation successful. Target is reachable." – This message suggests that LTM has reached the
target and all the expected LTRs have been received.
•
"LTM operation unsuccessful. Target not reachable." – This message suggests that LTM is success-
fully initiated but the target is not reachable.
•
"LTM operation unsuccessful. Target is reachable." – This message suggest that Target is reachable
but at least one of the LTR from intermediate hop is not received.
•
"LTM operation in progress." – This message suggests that LTM operation is in progress. This
message will appear if show CLI is fired before LTM Time-out time.
•
"LTM Timed out."- This message suggests that either LTM is not initiated properly or when none of
the expected LTRs is received in LTM Time-out duration which is 5 seconds.
Examples
-> show ethoam linktrace-reply domain MD association MA endpoint 10 tran-id 1256
LTM operation successful. Target is reachable.
Ttl : 63,
LTM Forwarded : yes,
Terminal MEP : no,
Last Egress Identifier : 00-00:00:D0:95:EA:79:62,
Next Egress Identifier : 00-00:00:D0:95:EA:9E:BA,
Relay Action : RLY_FDB,
OmniSwitch CLI Reference Guide
Specifies the domain name.
Name of the Ethernet OAM Association.
Specifies the MEP for which LTR is to be displayed. The valid range is
1-8191.
Specifies the Transaction ID or sequence number returned from a
previously transmitted LTM.
June 2012 page 45-67