Configure Router Mpls Static-Lsp Push Next-Hop - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router mpls static-lsp push next-hop

Pushes the specified label on to the label stack and specifies the IP address for the next-hop router in the
static Label Switched Path (LSP). After the push operation is complete, the packet is then forwarded to the
specified next-hop router.
configure router mpls static-lsp lsp-name push out-label next-hop ip-address
configure router mpls static-lsp lsp-name no push out-label
Syntax Definitions
lsp-name
out-label
ip-address
Defaults
N/A
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to remove the push label configuration associated with the static
LSP.
•
The LSP name specified with this command must already exist in the router configuration.
•
If an ARP entry for the next hop exists, then the static LSP is marked as operational. If an ARP entry
does not exist, then the static LSP is marked as operationally down and the local router continues to
ARP for the configured next hop at a fixed interval.
Examples
-> configure router mpls static-lsp to-R3 push 777 next-hop 192.168.10.2
-> configure router mpls static-lsp to-R3 no push 777
Release History
Release 6.4.2; command was introduced.
page 49-20
The existing LSP name.
An outgoing label number. The valid range is 32–1023.
The next-hop router IP address.
MPLS Static LSP and FRR Commands
OmniSwitch CLI Reference Guide June 2012