Configure Router Mpls Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router mpls interface

Configures MPLS support on an IP interface.
configure router mpls interface ip-intf-name
configure router mpls no interface ip-intf-name
Syntax Definitions
ip-intf-name
Defaults
By default, the MPLS interface is administratively enabled when the interface is created.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to remove the MPLS interface. Disable the administrative status of
the interface before attempting to remove it.
•
When the MPLS interface configuration is removed, any label maps or protect-swap label maps associ-
ated with the interface are also removed. However, static LSPs associated with the interface are not
removed; the static LSP configuration on the router remains in tact.
•
The IP interface name specified with this command must already exist in the router configuration.
•
Until MPLS support is configured on an IP interface, no other MPLS configuration tasks are allowed
on that interface.
Examples
-> configure router mpls interface vlan-20
-> configure router mpls no interface vlan-20
Release History
Release 6.4.2; command was introduced.
Related Commands
configure router mpls interface
shutdown
show router mpls interface
MIB Objects
vRtrIfTable
vRtrIfMplsStatus
page 49-4
The name of an existing IP interface.
Configures the administrative status for the specified MPLS interface.
Displays the MPLS interface configuration.
MPLS Static LSP and FRR Commands
OmniSwitch CLI Reference Guide June 2012