Show Router Ldp Bindings - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MPLS LDP Commands

show router ldp bindings

Displays the contents of the MPLS Label Information Base (LIB).
This section describes the base command (show router ldp bindings). Optional keywords are listed
below and described as separate commands later in this chapter.
show router ldp bindings
[fec-type {services | prefixes | fec-num} [session ip-address[:label-space]]]
[ingress-label start-label [end-label]]
[egress-label start-label [end-label]]
[prefix ip-prefix/mask [session ip-address[:label-space]]]
[active [prefix ip-prefix/mask]]
[vc-type vc-type [vc-id vc-id [session ip-address [:label-space]]]]
[service-id service-id]
Syntax Definitions
N/A.
Defaults
By default, the entire contents of the LIB is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the optional parameters provided with this command to display specific information for LDP label-
FEC (Forwarding Equivalence Class) bindings.
Examples
-> show router ldp bindings
LDP LSR ID: 10.10.10.5
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up,
E = Epipe Service, V = VPLS Service, M = Mirror Service,
A = Apipe Service, F = Fpipe Service, I = IES Service, R = VPRN service,
P - Ipipe Service
TLV = (Type, Length: Value)
LDP Prefix Bindings
Prefix
------------------+---------------+-------+------+-------------+---------------
10.10.10.5/32
10.11.0.6/32
No. of Prefix Bindings: 2
OmniSwitch CLI Reference Guide
D = Status Signaled Down,
Peer IngLbl EgrLbl EgrIntf/LspId EgrNextHop
10.11.0.6 131071U
10.11.0.6
June 2012
-- --
-- 131068 --
--
--
page 48-33