Show Service Fdb-Mac - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service fdb-mac

Displays the MAC address entry information found in the forwarding database (FDB).
show service fdb-mac [mac-address]
Syntax Definitions
mac-address
Defaults
By default, all MAC address entries are displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the optional mac-address parameter with this command to display information for a specific MAC
address.
•
Fields that display "N/A" are currently not supported.
Examples
-> show service fdb-mac 00:02:da:16:02:0c
Service Forwarding Database for 00:02:da:16:02:0c
ServId MAC Address
---------+-------------------+---------------------+----------+--------------------
2000 00:02:da:16:02:0c
No. of Entries: 1
output definitions
Service Id
MAC Address
Source-Identifier
Type
Release History
Release 6.4.2; command was introduced.
page 50-110
A 48-bit MAC address for the static ARP (aa:bb:cc:dd:ee:ff). Valid
addresses are any non-broadcast, non-multicast MAC, and non-IEEE
reserved addresses.
Source-Identifier
sap:16/6:2
The unique service identification number used to identify the service.
The MAC address entry associated with this service.
The Service Access Point (SAP) on which the address was learned or
configured.
The type of MAC address (Learned=dynamically learned address or
Static=management configured permanent address).
Virtual Private LAN Service (VPLS) Commands
Type Last-Change
Learn N/A
OmniSwitch CLI Reference Guide June 2012