Configure Service Vpls Mesh-Sdp Egress Vc-Label - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Virtual Private LAN Service (VPLS) Commands

configure service vpls mesh-sdp egress vc-label

Configures the static MPLS VC label used by this router to send packets to the far-end router using the
specified mesh SDP binding.
configure service vpls service-id mesh-sdp sdp-id[:vc-id] egress vc-label egress-vc-label
configure service vpls service-id no mesh-sdp sdp-id no egress vc-label
Syntax Definitions
service-id
sdp-id
vc-id
egress-vc-label
Defaults
By default, the egress VC label value is set to zero (0).
parameter
vc-id
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the no form of this command to remove the egress VC label from the specified VPLS.
Examples
-> configure service vpls 100 mesh-sdp 20 egress vc-label 131070
-> configure service vpls 100 mesh-sdp 20 egress no vc-label
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
An existing VPLS ID number.
An existing SDP ID number that is bound to the specified service ID
number.
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
The egress VC value that identifies a specific connection. The valid
range is 16–1048575.
default
service-id value
June 2012 page 50-45